How To Change The Bass On A Bose Speaker? – Tell You In Details

October 13, 2022 by No Comments

You have arrived at the ideal location if you were wondering how to adjust the bass on a Bose speaker. I’ll walk you through how to adjust the bass on a Bose speaker in this article.

Introduction

The bass speaker may need to be changed if you are experiencing any audio problems with the lower frequency sounds (the bass), such as distortion, muffling, quietness, or complete silence.

1. Battery

The SoundLink’s bottom panel’s rubber pads can be removed using a spudger.

When you put the rubber pads back together at the end, there ought to be enough adhesive for them to adhere. If not, however, you might require your own adhesive.

2. Use a Phillips #2 screwdriver to remove the two 12.5 mm screws.

It might be challenging to remove these screws. If additional torque is required, use a lever.

3. The SoundLink’s battery can be accessed by flipping the back panel.

4. From the sides of the battery, remove the two 12.5 mm Phillips #2 screws.

5. On either side of the inner back panel, carefully peel back the adhesive padding.

Although the adhesive on these pads is strong, if the first one starts to fail, you might need a new adhesive.

6. Four 12.5 mm Phillips #2 screws holding the outer case in place should be removed.

7. With a Torx #10 screwdriver, remove four screws from each of the four speakers for a total of sixteen screws.

All screws are 12.5 mm long, with the exception of the two middle screws on the right side. The middle screws mentioned earlier measure 21 mm.

8. Using a Phillips #2 screwdriver, remove the two 12.5 mm screws holding the top panel in place.

9. To disassemble the device, use a metal spudger. Given the significant force required to pry it apart, you must use a metal spudger.

10. With a Philips #2 screwdriver, remove the 12.5 mm screw holding the motherboard in place.

11. The three cables that are attached to the motherboard should be carefully disconnected.

Take the device’s motherboard out.

12. Using a Philips #2 screwdriver, remove the four 12.5 mm screws.

You will now be able to remove the bass speaker

Bose Speaker

How Do You Change The Bass On A Bose Speaker?

I’m going to provide a step-by-step tutorial so that you can use it to modify the bass on a Bose speaker. It’s as follows:

  • Press BASS Button from the Remote Control
  • Use + – Keys to change the Bass of Bose Speakers
  • Press the BASS Button so that you can save the Settings

An LED white light that blinks three times in a row appears when you press the bass button.

In case you’re using the optional wall bracket:

For about 3 to 5 seconds, hold down the dialogue or mute button on the remote control before the led light begins to blink. To turn off Wall EQ, repeat this.

To Turn Up Or Down The Amount Of Bass 

  1. In the Bose Music app, tap the Audio button.
    Tip: If a different product is shown, tap the My Bose icon in the upper-left corner then select the desired product.
  2. Under Audio Settings, use the + or buttons to adjust the bass or treble levels in increments of 10 (from -100 to 100)
    Note: Additional audio settings may be displayed for certain products

Conclusion

I hope this information is useful. The procedure for changing the bass is very easy to understand. Feel free to leave a comment below this post if you are having any other problems; I would be more than happy to assist you.